|
Product Details:
|
| CABLE: | 2Moil Resistance 4 Core φ48 Tensie,strength 30N,the Minimum Bending Radus R7 | Protectve Tube: | 1M Minimum Bending Radus R25 |
|---|---|---|---|
| Contact Surface Material: | Tungsten Steel | Surface Processing Method: | Ginding 4S Mirror |
MP21-10 /16tool set instrument is mainly used for CNC engraving and miling machine,highlight machine,glass jade machine and other equipment tool measurement,wear damage detection,broken tool detection;An alarm signal will ccur when the tripis exceeded,which can prevent damage accidents
Production Parameter:
产品名称/Product name | 自动对力仪/Automatictool checkinginstrument |
产品型号Mode | MP21-10,MP21-16 |
对刀面直径/Diameter of cautter face | φ10mm,φ16mm |
输出模式/Outout mode | NC常闭型/NO常开型/NCnormaly cdosed/NO normaly open |
预行程/Pretravel | 0 |
行程/Sroke | 5 |
重复精度/Repeatabit | 0001mm(条件:操作速度50-200mmmin/Condition operating speed 50-200mmmin) |
触点寿命/Contact life | 300万次3mllon time |
保护结构/Protection architecture | IP67*100%防水,防油密封性能1P67*100%waterproof oil-proof sealing perfomance |
接触力/Contact force | 1.5N(安装状态须垂直/nstalation must be vertical) |
接触面材料/Contact surface material | 钨钢/Tungsten steel |
表面处理方式/Surface processing method | 研磨4S镜面/Ginding 4S mirro |
触占额定值/Contact rating | DC24V-20mA(MAX)(推荐值/recommended 10mA)电阻负荷/resstance load |
电缆/Cable | 2m耐油4芯φ48拉伸强度30N,最小弯曲半径R7/2Moil resistance 4 core φ48 tensie |
strength 30N,the minimum bending radus R7 | |
保护管/Protectve tube | 1m最小弯曲半径R25/1MMinimum bending radus R25 |
安装孔距/The pitch of the instalation | 10-12mm |
净重Net weight | 193g(默认MP21-10的重量/defaut MP21-10 weight) |
手重/Gross weigh | 277g(默认MP21-10的重量/default MP21-10weight) |
超程报警信号/Overange dlam signal | 输出模式；NC常闭(距离检测信号约25mm)/Output mode:NCnomaly dosed (ange detection signalis about25mm) |
触点电压:DC24V-20mA(MAX)(推荐值10mA)电阻负荷/Contact voltage DC24V-20mA(MAX)(reommended | |
value 10mA)resistance load |
